[cooker-amd64] Sata and sensors for Tyan 2885

[Rui Pimenta]

Hi,

I am sorry for this late reply especially to Duncan 'coz I had to sort out 
lots here at the office.

SATA:
Fortunately I managed to install mandrake on my SATA HD (which are the only 
one that I have), Unfortunately I had to got with mdk 10 beta 1 (32 bit). 
This was the only version that could detect my SATA hard drives when doing a 
fresh installation. I do know know if there is a planned mdk 10 beta (amd64). 
If so can anyone tell me where because I would like very much to install it. 
Because the last version of the cooker still is the 9.2 I think. 

LM_Sensors:
Duncan asked about the LM_Sensors. Well they are working on mdk10. and what I 
did was just to install the LM_Sensors package and used the sensors file 
provided by TYAN loaded the modules that they mention and everything is 
working fine:

adt7463-i2c-1-2e
Adapter: SMBus AMD756 adapter at 50e0
Algorithm: Unavailable from sysfs
ERROR: Can't get alarm mask data!
CPU0 DDR 2.5:
           +0.000 V  (min =  +2.37 V, max =  +2.63 V)   ALARM
CPU0 DDR VTT:
           +0.000 V  (min =  +1.18 V, max =  +1.31 V)   ALARM
3.3VSB:    +3.317 V  (min =  +3.13 V, max =  +3.47 V)
+5V:      +5.104 V  (min =  +4.74 V, max =  +5.26 V)   ALARM
+12V:     +11.938 V  (min = +11.38 V, max = +12.62 V)   ALARM
FAN3 (REAR):
              0 RPM  (min = 3000 RPM)                     ALARM
FAN4 (BOTTOM):
              0 RPM  (min = 3000 RPM)                     ALARM
FAN1 (CPU0):
           3253 RPM  (min = 3000 RPM)                     ALARM
FAN2 (CPU1):
              0 RPM  (min = 3000 RPM)                     ALARM
CPU1 Temp:-128.00°C  (low  =  -128°C, high =  +127°C)     ALARM FAULT
System Temp:
          +25.00°C  (low  =  -127°C, high =  +127°C)
CPU0 Temp:+49.00°C  (low  =  -127°C, high =  +127°C)
pwm1 fan:  255
pwm2 fan:  255
pwm3 fan:  255
vid:      +0.000 V    (VRM Version  9.1)

cheers,
Pimenta